BLUE GUARDIAN
PRODUCT PROTECTOR
*Offer only available to metro area customers or customers within 50km of a TMHA Branch. Toyota Material Handling Australia (TMHA) has used its best endeavours to ensure brochure information is
correct when published. All images are used for illustration purposes only. Prices include GST. Prices effective from 1 October 2017 until 31 March 2018. TMHA reserves the right to change, without notice,
at any time prices, materials and specifications. TMHA, to the extent permissible at law, is not liable to any person for loss or damage arising from reliance upon information contained in this catalogue.
Distributed nationally byToyota Material Handling Australia Pty Limited ABN 38 104 644 635, 8 Secombe Place Moorebank NSW 2170.
1800 425 438
Product protection
• Reduces product damage by redirecting a forklift’s impact to
the center bearer of the pallet
• Avoids direct contact with product through low-profile bumper design
• Less debris and forklift tire damage as a result of fewer wood splinters
• Simple quick installation requiring no permanent modification to forklift
Innovative, universal design
• Compatible with any counter-balance forklift
• Effective with all pallets
Features
• Rubber bumper
- reduces product damage caused by forklift by
redirecting impact from the product to the pallet bearer
• Beam shape
- improves visibility and protection to forklift mast
• Structural ribbed design
- provides superior impact and
bending strength
$
125
Part No. 950-BLU/GRD
PRICE INCLUDES GST
5.
Pull free end of the leash
down through the hole
at the top of the Blue
Guardian (C) to bottom
of the Blue Guardian
and insert between the
bumper and the frame.
6.
Line the bumper up with
the front of the Blue
Guardian and insert the
bolts into the front of
the bumper with the
washer at the head of
the bolt and the split
washer between the Blue
Guardian and the back
plate.
3.
Lower tines to the ground
and slide a standard sized
pen (12 mm) under the
Blue Guardian frame. If
the pen does not pass
under the Blue Guardian,
there is not adequate
floor clearance and the
Blue Guardian should be
removed.
7.
Holding the back plate in
place, tighten all 3 bolts
from the front side of the
Blue Guardian.
4.
Raise the tines to a
working height and slip
leash around the carriage
and through the loop. If
there is enough length
wind the leash around the
carriage one more time.
Then thread this through
bottom of backrest.
8.
The Blue Guardian is
installed.
1.
Clean channel and center
notch of the forklift
carriage. Make sure it is
clear of wood splinters
and other debris.
A
C
2.
Locate the Blue Guardian
on the lift carriage by
placing the tab on the
back of the Blue Guardian
(A) into the center notch
of the forklift carriage (B).
The Blue Guardian should
hang flush against the
forklift carriage face.
B
Features and benefits
Blue Guardian Product Protector
- Installation guide
CONTENTS
a) Blue Guardian
b) Leash
c) Back plate (1)
d) Bumper (1)
e) Bolts (3)
f) Split washers (3)
g) Washers (3)
a
b
c
d
e
f
g
All Prices include GST
EACH
(SUPPLY ONLY)
EXCLUSIVE TO
Your local TMHA branch
can fit the Blue Guardian
for the additional cost of -
$
105
(INC GST)
